Thanks to the hydroponic pH&EC Controller control system, you no longer have to worry about filling your tank with water, as well as regulating EC (electrical conductivity) and pH (acidity) values and watering itself — it will do it all for you.
Using the pH&EC Controller, you can automatically set the optimal pH and EC values for water. After these values are set, you can start the irrigation pump and fill the tank with water.
The hydroponic pH&EC Controller system consists of two pumps for adding liquid fertilizers and one pump for regulating the pH level. It is equipped with a configurable program for automatically starting the irrigation pump in two different ways:
- Continuous, well suited for reversible hydroponic and aeroponic systems.
- Periodic (up to four times a day), equally well suited for both non-reversible hydroponics systems (substrate) and for the earth.
If you have purchased additional accessories (maximum and minimum water level and alarm sensors, an electromagnetic valve and a flow sensor), you can also:
- Monitor the filling of the tank with water through the maximum and minimum level sensors, as well as have an alarm sensor to turn off the irrigation system in case of emptying the tank;
- Turn on the solenoid valve to fill the tank or reverse osmosis system.
The flow sensor activates the regulator in the presence of water movement in the regulator and turns off the irrigation system when it detects insufficient water in it.
Application: greenhouse, hydroponics, greenhouse, hydroponics, greenhouse, hydroponics.
equipment:
1. Instruction manual — 1 pc.
2. Acidity and electrical conductivity regulator with two built-in pumps for applying liquid fertilizers and one pump for regulating the pH level - 1 pc.
3. Electrical conductivity sensor (EC) connected to the controller — 1 pc.
4. pH (acidity) sensor — 1 pc.
5. One plastic collector:
- 1/2" tee — 5 pcs.
- 1/2" threaded nipple — 4 pcs.
- pH sensor holder - 1 pc.
- 1/2" hose connector, 16 m — 2 pcs.
- teflon tape — 1 pc.
- fitting 3/8”-1/2" - 3 pcs.
6. Nozzles — 3 pcs.
7. Suction filter of the cylinder — 3 pcs
. 8. Polyethylene pipes in rolls of 10 m — 3 pcs
. 9. Additional accessories:
- Water level sensors — 3 pcs.
- Flow sensor - 1 pc.
- Electromagnetic filling valve — 1 pc.
